The glass drilling machine is an industrial machinery and equipment. You must be careful when using it. You must master the methods of using the glass drilling machine and the precautions for the use of the glass drilling machine. First of all, before the work starts, the method of using the glass drilling machine is to inject lubricating oil into each oil filling part first, and clean the core material in the receiving drawer in time. Secondly, the precautions for the use of the glass drilling machine include: do not touch the moving parts when the machine starts, live parts, and emergency situations, immediately press the "emergency stop" button or pull down the air switch, etc. Let's continue to look at the specifics!

1. How to use the glass drilling machine

The glass drilling machine is a machine specially used for drilling glass. It is mainly divided into: base, operating table, drill bit, motor, etc. The diameter of the drilling hole is large, and the overhang space of the machine base is large, which can drill holes in various sizes of glass. Work, the height of the worktable is low, the operation is convenient, and the lower drill bit adopts air pressure speed regulation, and the speed is stable. It is an ideal drilling machine for glass processing enterprises. So do you know how to use a glass drilling machine?

1. When drilling glass, the lower drill bit is easy to crush the glass, so when drilling thin glass, the pressure must be adjusted very low, which can be changed in the range of 0.18 ~ 03MPa, and when drilling thick glass, the pressure can rise to about 0.46MPa .

2. Before the start of each shift, lubricating oil should be injected into each oiling part first, and the tightness of the belt should be checked, whether the upper and lower drill shafts are running abnormally, and whether the drill bit is worn, and the work can be started after everything is normal.

3. The core material in the receiving drawer should be cleaned in time, otherwise too much material accumulation will jam the receiving device. Especially when drilling large holes with a diameter greater than 100mmj, it should be cleaned every few holes drilled.

4. When cleaning the core material, the receiver should be in the receiving position, so that the receiving drawer can be pulled out smoothly. Therefore, when cleaning the core material, the drill should be started to rotate. At this time, the receiver will be in the receiving position, which can be easily cleaned. material core.

2. What are the precautions for the use of glass drilling machines

After understanding how to use the glass drilling machine, the precautions during use must also be clear:

1. Pay attention to safety when debugging and using the glass drilling machine. Do not touch the moving parts and live parts when the machine is started.

2. Do not put tools and other objects on the conveying rail and cover.

3. In case of emergency, immediately press the "emergency stop" button or pull down the air switch.

4. Pay attention to the grinding situation of the glass drilling machine at any time: the loss of the grinding wheel should be compensated by the feed in time.

5. Keep the cooling water in the water tank sufficient and the water quality clean at any time, so as not to burn the grinding wheel and glass, and clean up the grinding impurities in the water inlet and outlet pipes in time to keep the waterway unobstructed.

6. Before working, check whether the travel switches of all glass drilling machines work normally and whether the control direction is correct. If it is not correct or the control direction is wrong, it should be stopped immediately for inspection, otherwise the glass drilling will be fatally damaged.

7. Do a good job of personal protection, wear goggles and cut-resistant gloves. Shoes and clothing with bare skin are prohibited to prevent cuts.